 Most viewed - User galleries |
Step 10: resistor R2 (15k Ohm)713 viewsthis is the resistor R2 (15k Ohm) that needs to be replaced with a 10.2k Ohm unit
|
|
Step 12: resistor R2 (15k Ohm) partialy desoldered710 viewsresistor R2 (15k Ohm) partialy desoldered
|
|
Water/Oil cutout dimensions704 viewsWidth 79.7mm; Height 15.7mm
|
|
Step 07: circuit and motor revealed704 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.
|
|
702 views
|
|
Step 05: fascia panels698 viewsremove the two fascia panels
|
|
Conversion test successful695 views10.44kOhm instead of 15kOhm
|
|
Step 06: light distributors694 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegs
|
|
692 views
|
|
Step 03: tacho and speedo needle685 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)
|
|
Step 01: retaining tabs top (3)681 viewspush down on the 3 retaining tabs on the top (best start on the side) to loosen the transparent cover
|
|
672 views
|
|
14 drawer cabinet667 views
|
|
659 views
|
|
647 views
|
|
| 528 files on 36 page(s) |
 |
3 | |
|
|
|
|
|
|
|
|
|
|
|
